NZFF

Hi Guys,

I've had an academic licence for P3D for a while but have not really been happy with the stock sim appearance or performance until v2.3 came out. I'm liking what I see now, and want to add REX cloud and water textures to the program- but am unsure on the procedure?

I went to my account page on the FlightSimStore and am redownloading the install file for REX Essential PLUS. Is it simply a case of opening the .exe file when it completes and choosing Prepar3D over FSX during the install process? Or will Windows spit the dummy that I have FSX installed with REX already active on the same harddrive?

Also- are there any other ATI card users on the forums who've gone into the CCC or RadeonPro toolkits to tweak performance and display settings for P3D? I'm a little overwhelmed with all the different settings, and am still getting subtle tears in my terrain, and other screenshots I've seen look much crisper than my own...?

Cheers!

ardypilot wrote:

QUOTE (ardypilot @ Aug 19 2014,1:59 PM) <{POST_SNAPBACK}>

I went to my account page on the FlightSimStore and am redownloading the install file for REX Essential PLUS. Is it simply a case of opening the .exe file when it completes and choosing Prepar3D over FSX during the install process? Or will Windows spit the dummy that I have FSX installed with REX already active on the same harddrive?

When FSX was first released I still had FS9 install on the very same HD , after a few months specific after airport design and builds part off what I was doing bleed into the newer program and cause all sorts of problems .

I stop this by putting FSX onto a separate HD and everything settle down , wonder if that is the same issue ? .. maybe partition the HD or easier put a new HD in .

Think you misread Ian

This page might help http://www.realenvironmentxtreme.com/forum...sx-to-prepar3d/

Not sure, you may have to check the REX forums. As far as I was aware only their (newly patched for P3D2.3) REX 4 Texture Direct was compatible? Probably not true technically, under the hood.

I think I just purchased the P3D access rights ($10?) , directly from the REX panel. It now reads 'P3D activated' where the purchase button was.
I now use it exclusively in P3D, but it is a simple process to switch it to FSX -- I just browse to the FSX folder, in the REX Config Manager.
You can't just set and forget for both, though, which is a nuisance.

Could you post a screen grab of where that purchase button/activated button is please Robin? Found it hidden away in the Configuration Manager.

I was under the impression I was going to have to spend my rainy day off uninstalling and reinstalling the whole thing. The REX forums are a mindfield- the naming of the updates of their products are so confusing that I've steered clear for a long time and am fingers crossed that the version I have will meet the requirements for both sims!