GENERALISED AIRCRAFT PROCEDURES/CHECKLIST

Discuss aircraft addons and repaints for Flight Simulator here

Postby ScottyB » Wed Nov 26, 2014 8:33 pm

Hi all,

Being a real life flying instructor, I know how important it is to religiously adhere to Procedures, and then confirm those procedures with a checklist. I notice that many people just jump in an hit Ctrl-E and fly. For those who are after a more realistic experience, feel free to use the method below.

Thanks,
ScottyB

ps: Glad to be back here after a while!

------------------------------------------------------------------------------------

PRE START PROCEDURES

BRAKES - On
FUEL - Lowest Tank* (if a/c only has one tank there is no need for this)
FLAPS - Check (lower and raise flaps to check working)
TRIM - Check
MIXTURE - Rich
CARB HEAT - Off (cold)
MASTER SWITCH - On
ANTI COLLISION LIGHTS - Off
NAV LIGHTS - On
FUEL PUMP - On
FUEL PRESSURE - Check (positive pressure)
ENGINE - Prime
THROTTLE - Set (open just slightly)
PROPELLER - Check clear
STARTER - Engage

AFTER START PROCEDURES

THROTTLE - 1000 RPM
OIL PRESSURE - Check (positive rise in pressure)
OIL TEMPERATURE - Check
FUEL PUMP - Off
FUEL PRESSURE - Check
MAGNETOS - Left > Right > Off > Both
RADIO - On
TRANSPONDER - Standby
ATIS - Copied

RUN UP PROCEDURES

BRAKES - On
FUEL PUMP - On (if about to change tanks)
FUEL - Fullest tank* (if run ups aren't require the aircraft should be started on the fullest tank)
FUEL PUMP - Off
T's AND P's - Check Green
MAGNETOS - Left > Right > Both
ALL CLEAR - Check (check for people, cones, any obstacles around a/c)
THROTTLE - 1800 RPM
BRAKES - Holding
T's AND P's - Check Green
CARB HEAT - Check (apply carb heat and look for positive RPM drop)
MAGNETOS - Left > Both > Right > Both
VOLTMETER - Check
AMMETER - Check
SUCTION - Check
THROTTLE - Close Fully
SLOW RUNNING RPM - Check within published limits
CARB HEAT - Check
OIL PRESSURE - Check Green
THROTTLE - Back to 1000 RPM

PRE TAKEOFF PROCEDURES

TRIM - Set
THROTTLE FRICTION - Set
MIXTURE - Rich
CARB HEAT - Off
FUEL - Check (####, Contents, Pump On, Pressure, Primer Locked)
FLAPS - Set for Takeoff
IGNITION - Both
INSTRUMENTS - Check
CIRCUIT BREAKERS - Check
HATCHES AND HARNESSES - Secure
CONTROLS - Full and Free
RADIO - Set

RUNWAY ENTRY PROCEDURES

TRAFFIC - Check Clear
WINDSOCK - Check Favourable
TRANDSPONDER - Alt
LIGHTS - As required
Compass - Check

Last edited by ScottyB on Wed Nov 26, 2014 9:44 pm, edited 1 time in total.
Image
User avatar
ScottyB
Sim-holic
 
Topic author
Joined: Thu Aug 30, 2007 3:58 pm
Posts: 571
Location: New Zealand

Postby Splitpin » Wed Nov 26, 2014 9:56 pm

Glad to see you back Scotty , but I'm sooo sorry , Im a" ctrl E " guy ....sometimes it's worse , I'm a "Y+F4" person ..... just to get those pesky non crtl E models going.

But, for those that push the buttons , a great post thumbup1.gif
User avatar
Splitpin
NZFF Pro
 
Joined: Mon Aug 03, 2009 12:15 pm
Posts: 21332
Location: Christchurch NZ

Postby Ian Warren » Thu Nov 27, 2014 7:07 am

I do like the procedure, A2A Cessna was classic example off not following my pre-flight , I took off with broken elevator hinges laugh.gif
Image
User avatar
Ian Warren
NZFF Pro
 
Joined: Fri May 05, 2006 5:23 pm
Posts: 41187
Location: AREA 51

Postby chopper_nut » Thu Nov 27, 2014 9:26 pm

I don't think I've ever used a printed checklist, real or simulated..... but good info
Last edited by chopper_nut on Thu Nov 27, 2014 9:27 pm, edited 1 time in total.
Image
Image
Image
User avatar
chopper_nut
NZFF Pro
 
Joined: Wed Oct 25, 2006 9:58 pm
Posts: 2977
Location: Wherever the work is

Postby Ian Warren » Thu Nov 27, 2014 9:54 pm

Going sim wise ... the A2A experience proved ya can't kill ya-self ohmy.gif
Image
User avatar
Ian Warren
NZFF Pro
 
Joined: Fri May 05, 2006 5:23 pm
Posts: 41187
Location: AREA 51


Return to Aircraft

Who is online

Users browsing this forum: No registered users and 12 guests