NZFF

Is there a simple way to do this? The aircraft I'm most concerned about is Nigel Booths SH-2G. While I don't mind so much that the VC is fairly basic, I'd like to be able to read the gauges which I cannot do currently! Any help appreciated :-)

When this was made alot of people tryed to do this ,you can in the panel cfg swap gauges maybe with default sim gauges that will make it higher res ,you open the panel cfg found in the aircraft folder /panel with notepad ,open up another cfg from a default aircraft and swap the names of the gauges over but not the numbers as they refer to the placement of the gauge ,swap the lines under VC_ and 2d if you use those ..
mike

Is your VC quality set to high in your display settings?

steelsporran wrote:

QUOTE (steelsporran @ Jan 20 2010, 04:22 PM) <{POST_SNAPBACK}>

Is your VC quality set to high in your display settings?

yes... that's the first thing I checked.