NZFF

Posted: **Tue May 04, 2010 2:41 pm**

I guys,

I dowloaded addon scenery for NZWN, NZCH, and NZQN, but am havinbg issues with all three (look at screenshots)

1. NZQN - Lake levels are up the wops. Needs some serious flattening?

2. NZCH - AI Parking/taxiing is mucked up. What do I do?

3. NZWN - Again AI Parking/taxiing is mucked up. What do I do?

Posted: **Tue May 04, 2010 3:00 pm**

I don't know about you, but my Queenstown manual has this:

QUOTE

Secondly there is Christian Stockâ€™s FS2002 Lakes Fix that is mandatory for his scenery and also works for FS2004 (included in this package, installation instructions further
down). This does not completely fix the problem of Lake Wakatipu being surrounded by towering cliffs but hugely improves it at least temporarily until Christian has released his
brand new Lakes, Rivers and Roads Upgrade for FS2004 in a few weeks. You can see some screenshots at Robinâ€™s site http://www.windowlight.co.nz and below I have shown
the differences between with or without the Lakes Fix for FS2002 (shown in FS2004).[/quote]

These days, 'Roads & Rivers' is the recommended fix, as it offers so much more to FS2004. However you will need one or the other suggested fix, but not both!

Note too sure about the other issues, but 99% of the time this is caused by extra AFCAD files, which over-ride the customised facilities data which is included with the airport. There are many ways to pick up these extras, in things like AI traffic addons which supply extra parking. Be aware that for custom airports, you can only have one AFCAD file, and it needs to be the one supplied with the addon, or at least based on it.

NZFF

NZ airport scenery issues