Page 1 of 1
Posted:
Fri Dec 08, 2006 3:23 pmby Pato
Is anyone using this Card or has used it?. I am advised that I should check the anti-aliasing and anisotropic filtering but my settings just say "Application preference" for both settings. I don't see where I can adjust them. Can anyone help?.
Pat.
Posted:
Fri Dec 08, 2006 4:08 pmby gokanru
Normally you would uncheck application preference and somewhere you will see custom.Click custom,and you can then adjust your settings manually
Posted:
Fri Dec 08, 2006 4:59 pmby Pato
Many thanks. That is the info I was seeking and I can now make some adjustments to see if things improve. Cheers,
Pat.
Posted:
Fri Dec 15, 2006 3:33 pmby Timmo
Did you notice any difference setting the antialiasing on the card? I tried turning it on via the card settings and turning it off in FSX.....but that just resulted in no anti aliasing? (i.e. blocky looking graphics) and didnt improve frame rates...
Posted:
Fri Dec 15, 2006 6:24 pmby creator2003
i have mine turned off inside fs9 or fsx altogether then go to my destop right click go to propertys/settings/advanced/ like the pic below then switch of ap controled and do 4x and 8x for your setting ,should work then just fine
hope this helps and i read the above properly
mike
