NZFF

Hi guys,

This is a bit strange but seems that the NZWN ILS is off a bit (for both RWY 34 and 16). I'm perfectly aligned with it here:



As you can see I'm off to the left (quite a bit actually).

Is this a known issue?

Dan

Ok, let's see if I can approach this form a different angle:

Is there an AFCAD editor program where I can check that the localizer "path" is correct? I can't land in Wellington using ILS as it puts me about 50ft aside the runway.
The NAV track setting is correct (161/341 degrees). Any suggestions?

Dan

I have edited Wanganui without the H ORBX runway due it be offset to the photo using the AFX program, as you would no ILS on this airport nor is there at Milford but i recall there was a similar issue when Mike did his scenery there in regard to offset placement , good example was Foxpine , i had to raise that up 10ft to match ORBX .

I wonder - and this is what i use landing into Wellington was Rob's RealNZ Wellington scenery with my 146 the tracking on the ILS was near smack on , It would not surprise me that ORBX AFCAD was out .

I give it a spin myself later this afternoon .

just had a look using AFX and the ILS is recorded at 183 degrees.
Thats with orbx NI installed.(the stock afcad reads the same)