NZFF

I have payware Auckland City & freeware Akl Airports installed [not Akl 2005] & i am looking for an easy way to remove the right hand runway "05R". Years ago i was able to do this but i've lost track of the procedure to do this. Please advise what files are required together with the process. I have been using FS9 for many years & am loathe to change!

Frankly DC3 AFX is the only program I recall for FS9 ..first program I used was by Derek Leung's FS Airport Design.

Hi DC3 is this what you want?
https://flyawaysimulation.com/downloads ... t-scenery/

Good on ya Les ..

why do you want to remove 05R?

05R and 23L are the standard runways at Auckland, taxiway Bravo runs directly adjacent to the domestic apron then taxiway Alpha is south of that and then 23L/05R.

cheers

Ah! A True Flightsimmer!

Here's the runway layout:



PM your email address if you need the AFCAD file.

My thanks to everyone who responded. I found i needed to uninstall akl airports & replace it with akl 2005 followed by akl2005-2006_update v1.1 which removes 05R runway. Not sure if this is correct but someone out there will speak up!

you need to remove 05LEFT or it's just not Auckland

The ONLY current runway at NZAA Auckland International is 05 RIGHT/23LEFT.

If this is not the case then I've been putting tin on and off the wrong concrete for the last 30yrs

towerguy wrote:you need to remove 05LEFT or it's just not Auckland

The ONLY current runway at NZAA Auckland International is 05 RIGHT/23LEFT.

If this is not the case then I've been putting tin on and off the wrong concrete for the last 30yrs

That is why Harrison Ford is always getting it wrong !.... TRUE