Posted: Sun May 17, 2009 10:18 pmI am using and ALPS EC11B dual rotary encoder but have been unable to find any knobs to it the shafts. Can anyone point to somewhere I might find some suitable knobs.
The shaft sizes are 6 mm and 3.5 mm. The outer (6mm shaft) knob locates with two parallel sided slots on opposite sides of the shaft and the inner (3.5 mm shaft) knob is located with a flat on the shaft.
The shaft sizes are 6 mm and 3.5 mm. The outer (6mm shaft) knob locates with two parallel sided slots on opposite sides of the shaft and the inner (3.5 mm shaft) knob is located with a flat on the shaft.