NZFF

Out of NZMC, down to Glentanner to gain height, doubling back towards Aoraki before slipping over the Copland Saddle then down the Copland Valley.

Thanks to MDIvey for the Buffalo, the mesh and photoscenery are by GeoffKiwi

Mike .....

I'll be in that neck of the woods toward the end of the year.
I will go find out the truth!

I have always thought the MS NZ mesh was just too rounded - no sharp ridgelines, and just not craggy enough.
I had VLC in my FSX, and the Red Baron mesh and topo in my old FS9, and from what I have seen on my RL visits to NZ, I see no reason to change that view.
I am staying with AFS4 because it will run under Linux. Current policy is to get rid of MS and all their works and pomps.

You have a point there, Mike.
Pretty spiky mesh, too.