NZFF

by **scon** » Sat Apr 14, 2007 8:59 pm

After finding out from ZK-TJL last night that the default NZCH (FSX)does have airbridges ( mine were being disabled because of the Just Fight Traffic AfCAD ) I got them working today. But half of them aren't connected to a building they just hover in mid air does anyone else have this problem

If so I will create a quick fix for it (using abacus scenery placer) and upload it

by **JonARNZ** » Sat Apr 14, 2007 9:12 pm

Hmm, this doesnt sound right, as you would have seen in the FSX multiplayer screenshots they should sit normally, at least thats my experience with them anyway.

You dont have any third party add-ons for that area do you, perhaps AFCAD files?

by **scon** » Sat Apr 14, 2007 9:15 pm

So all your jetways connect to a building

by **JonARNZ** » Sat Apr 14, 2007 9:20 pm

Certainly do

by **ZÃƒÂ¶ltuger** » Sat Apr 14, 2007 9:26 pm

I found that when I was in NZCH today, though I know for a fact that there's normally a building there in single player if you have your scenery up high enough (which I don't)

by **scon** » Sat Apr 14, 2007 9:37 pm

Well it has been fine up to now but it just started happening ( I have scenery to Max) I am doing another test now

by **ooOO00OOoo** » Sat Apr 14, 2007 9:43 pm

try without the J.F AFCAD. If it works and the AI aircraft land on the side(join the club) then edit the traffic files. I belive you can do that.

by **scon** » Sat Apr 14, 2007 9:59 pm

Yep getting rid of the JF afcad is what got the Jetways to appear in the first place but after the main terminal building everything alse is not there untill you get to the hangars

by **ooOO00OOoo** » Sat Apr 14, 2007 10:28 pm

set scenery complexity to dense or above.(the one above autogen complexity)
and make sure all scenery is set to a dencent level, not very low :thumbup:

by **JonARNZ** » Sat Apr 14, 2007 10:32 pm

It's interesting because the airbridges are usually the first things to disappear depending on your scenery LOD, so if the bridges are appearing it suggests your scenery settings are already quite high.

This really does sound like a scenery clash somewhere, and one of the reasons I am loathe to install anythingt that is not FSX specific. Hope you get it sorted and can tell us what the reason was.

by **scon** » Sat Apr 14, 2007 10:39 pm

Well I got it sorted allright and Jon your not going to like it

The problem was caused by the NZFF scenery, I have tried everything and with NZFF on I get the NZCH problem NZFF off no NZCH problem

I will do further tests tomorow

by **JonARNZ** » Sat Apr 14, 2007 10:45 pm

Interesting, I'll have to take a look myself in that case, not that its an issue given the scenery is for a specific purpose so can be turned on and off as required. Be interesting to understand why it does that given Davids Taranaki didnt cause anything strange.

I'll be keen to know if others have had the same issue using NZFF.

by **scon** » Sun Apr 15, 2007 9:37 am

I am just about to turn NZFF back on and see if I cycle it if that makes ay difference ( it's been on then off then back on )

by **ZÃƒÂ¶ltuger** » Sun Apr 15, 2007 11:19 am

that's interesting actually, because I installed NZFF just before I flew yesterday and noticed the lack of buildings at NZCH

by **scon** » Sun Apr 15, 2007 12:55 pm

Yep tried it again still NZFF

Here is my theory, FS only allows a certain abount of default buildings in one area, becuase NZFF, and NZCH both use default buildings one of them has to be zffected, NZFF has the higher priory so NZCH is affected

by **JonARNZ** » Sun Apr 15, 2007 7:36 pm

OMG, where have all my buildings gone at NZCH :lol:

Hmm, oh well, the problem is consistent if nothing else.

by **scon** » Mon Apr 16, 2007 9:10 am

JonARNZ wrote: OMG, where have all my buildings gone at NZCH

Hmm, oh well, the problem is consistent if nothing else.

No the airbridges are there but half the terminal is missing

by **ooOO00OOoo** » Mon Apr 16, 2007 9:13 am

scon wrote:

No the airbridges are there but half the terminal is missing [/quote]
oooo that happened to me at Wellington when i first started. Are you sure the scenery complexity is dense or above? I use Extra dense.

by **JonARNZ** » Mon Apr 16, 2007 9:25 am

scon wrote:
JonARNZ wrote: OMG, where have all my buildings gone at NZCH

Hmm, oh well, the problem is consistent if nothing else.

No the airbridges are there but half the terminal is missing

'all' is figurative, not literal. Half the terminal remains as do all the airbridges...

by **scon** » Mon Apr 16, 2007 10:34 am

JonARNZ wrote:
scon wrote:
JonARNZ wrote: OMG, where have all my buildings gone at NZCH Ã‚Â

Hmm, oh well, the problem is consistent if nothing else.

No the airbridges are there but half the terminal is missing

'all' is figurative, not literal. Half the terminal remains as do all the airbridges...

Oh

This just confirms Confirms that there has been a conspiracy by Microsoft that all of my FS's right from 98 DO NOT LIKE ME <_<

NZFF

NZCH Airbridges

Who is online